We bought a Zippi run to replace a good locally made wooden run for our bunny, so the run already had a high bar to reach.
I’m pleased to say, this run didn’t disappoint.
The extra height meant my bunny now had the space to jump on top of boxes and a little house, as well as hide beneath it. The skirt and mesh used also is such good quality it gave me a lot more confidence to leave him in the run while I went to work.
We actually got a second rabbit to bond with the first and bought another one of these, standing them next to each other. This meant not only could both bunnies exercise but they could sit alongside each other and lick each other through the bars before their introduction. They are now bonded!
We’ve had wooden runs before and they simply haven’t lasted, this looks like it will last a look longer. It was easy to assemble and is sturdy enough once fully built.
I did not pay close enough attention to the picture showing the dimensions and hadn’t realised the dimensions shown included the skirt so I was disappointed on the size front but that’s my own fault.
We opted for the double height because the single height is most definitely not tall enough for a rabbit.
Getting in and out isn’t easy so catching the rabbits is a bit of a hassle and there’s no way my husband would be able to get in.
We did however buy this run as a stop gap with the intention to increase the size and add a connector tunnel to the rabbits shed at a later date and for this reason I think the run is very good value for money
My house and run combo are linked by tunnels to this run, to give my buns a bit more space. I am going to buy the extending panels though as it is still not that big an area. My rabbits much prefer having the run with skirt and being on the grass, rather than the underfloor mesh in the run. Be warned this is not quick to put together - loads of small pieces that have to be clipped together with small plastic clips. It is more sturdy than you think it is going to be, but I still like to put it near a wall where it can't be knocked over. Having the pre-cut door for adding a tunnel is a big relief as cutting the mesh of the run was a nightmare.